« Ikea Locations – Find Ikea Locations quickly without getting lost on their site
Best People Search And Back Ground Search »

10.Schonstedt Utility Locator- Application Telephone & Cable

Tracing telephone and cable using the conductive mode, the inductive mode or leapfrogging. Plus tips to consider when setting up and tracing the signal.

EngineerSupply is a Factory Authorized Dealer for Schonstedt Magnetic Locators.

Duration : 0:2:20


[youtube HtmQBL4LouY]

This entry was posted on Friday, December 18th, 2009 at 3:11 am and is filed under locators. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

3 Responses to “10.Schonstedt Utility Locator- Application Telephone & Cable”

  1. evergreencreativeart on December 18th, 2009 at 3:11 am

    I more familiar …
    I more familiar with metro tech’s cable locater system. And the gain is automatic. I figure when I start locating, I compare the gain from where I know I’m directly over the cable to where I am locating it. If the gain stays about the same, then I feel more confident that I’m on the right cable. I wish I understood gain better to improve my cable locating in congested areas especially.

  2. Gain is very …
    Gain is very similar to sensitivity. If you have a large area and are trying to find the line set the gain on high. Once you narrow in on the line you want to follow turn the gain down to reduce interference from other lines.

  3. evergreencreativeart on December 18th, 2009 at 3:11 am

    Do you use gain as …
    Do you use gain as part of the locater method?

Leave a Reply